Setting camera and ceiling heights in the 3D Editor

Setting camera and ceiling heights in the 3D Editor is available as part of the Beamo Plan(s) Essential, Pro, Enterprise.
Learn how to get more out of Beamo with Plans and Packs.


Get accurate measurements in the 3D workspace by setting the RICOH THETA camera lens and ceiling height. Setting the ceiling height also enables you to measure from the ceiling in the 3D workspace.

Who can use this feature? 

  Super Admin Site Manager Team Admin Surveyor Collaborator Viewer
3D Editor :check_mark: :check_mark: :check_mark: :check_mark: :minus: :minus:

Setting camera and ceiling height


      1. Click [Settings] on the image view.

      2. Enter the Camera height and click [Apply]

      3. Enter the Ceiling height of the site where the survey was taken. 

      4. If you don’t know the height, click [Not sure? Measure from the 360 images]. On the 360° image screen, click on the edge where the floor and wall meet. Then click again on the ceiling following the white circle on top as a base. 

      5. Click [Save] and apply the height to the survey.

Note: If you uploaded the survey from the Beamo App, the RICOH THETA camera height (tripod height) is already saved as you have set in the app.

Caution: After applying the camera height and ceiling height, the survey itself will also be saved and updated.


Was this article helpful?
1 out of 1 found this helpful