Capturing using manual mode

Introduction

Useful to capture the site where the time requires to move between each point is different or where you want to stop and check the detail of your site while capturing.  Capture with auto mode or using BLE remote controller.

 

Who can use this feature? 

  Super Admin Site Manager Team Admin Surveyor Collaborator Viewer
Beamo App :check_mark: :check_mark: :check_mark: :check_mark: :minus: :minus:

 

Capturing using Manual mode

 

c1.png

1. After the calibration is done, tap the capture button. 
(See the capture UI to find the capture button)

c2.png

2. Please wait until the process icon disappears.

c3.png

3. If the process is successfully done, you can see the point with a number.  Move to the next point to proceed with the capture. If you feel like you captured the wrong place, you can preview the image, delete, or move the captured point without leaving the capture UI.

4. When you finish with capturing, tap [Done] on the top-left of the screen.

 

c4.png

  5. Tap [OK] in the confirmation message box. Proceed next step, import, and upload.
      Or you can add a tag to the survey.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.